Interior drain tile, sump basins, and vapor barrier wall systems installed by technicians who've done this hundreds of times in Richmond, MN basements.
Basement waterproofing mistakes usually come down to one thing: fixing the symptom instead of the source. A contractor who paints over a wet wall without checking cove joint condition or exterior grading is setting you up for the same call again in a year or two.
We're bonded and insured for both residential and light commercial basement work across Richmond, MN.
Most inspection requests get a same-day or next-day appointment, not a two-week wait.
No hourly billing and no change orders once your basement floor is already open.
We use pin-type moisture meters and a flashlight-and-crowbar inspection to trace water back to its real entry point.
We scope every Basement Waterproofing job in person before quoting it, since two properties with the same symptom rarely need the same fix.
The core fix for most Richmond, MN basements: a perimeter drain cut into the slab edge, tied to a sump basin, that intercepts water before it reaches the floor.
Battery backup is available for any sump system, so a power outage during a storm doesn't undo the whole fix.
The cove joint where the floor meets the foundation wall is one of the most common Richmond, MN leak points, and we seal it as part of every interior system.
We install membrane on masonry walls before any insulation or framing goes up, so moisture never gets a chance to reach finished materials.
Window wells that hold water after a storm are a direct pressure point against the glass and frame — we add gravel beds and drain lines tied into the main system.
A quick phone conversation lets us bring the right equipment on the first visit instead of a second trip.
A technician walks the basement with a moisture meter, checking walls, floor, and cove joints to trace the water back to its actual source.
You'll see drain tile footage, sump specs, and labor broken out separately, not one vague lump-sum number.
Most residential basement jobs finish in one to three days, and we test the sump pump under load before we leave.
"We'd patched a basement crack twice ourselves before calling. The interior drain tile system actually fixed it instead of just hiding it again."
— Richmond Homeowner
"Sump basin was undersized from the last owner's DIY job. They resized it and we haven't had a drop since."
— Richmond Customer
"They walked us through exactly why the water was coming in before quoting anything, which no one else had bothered to do."
— Richmond Homeowner
"Basement had been damp for years. Drain tile and a new sump system fixed it in three days."
— Richmond Customer
Every Richmond, MN quote is itemized in writing so you can see exactly what drives the total.
We keep the cut as narrow as possible and clean up debris before leaving the site.
Most residential interior drain tile and sump installations finish in one to three days depending on basement size.
Not always — an isolated, non-leaking crack can sometimes be handled with injection alone.
We provide photos and moisture readings that many Richmond, MN homeowners have used to support a claim.
Warranty terms are often transferable if you sell the property later.
We install interior drain tile and sump systems throughout Richmond and the surrounding Richmond, MN service area, including the zip codes listed below.
Zip codes we serve in Richmond, MN: 56368
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
