Interior drain tile, sump basins, and vapor barrier wall systems installed by technicians who've done this hundreds of times in Portland, OR basements.
Basement waterproofing mistakes usually come down to one thing: fixing the symptom instead of the source. A contractor who paints over a wet wall without checking cove joint condition or exterior grading is setting you up for the same call again in a year or two.
We're bonded and insured for both residential and light commercial basement work across Portland, OR.
Most inspection requests get a same-day or next-day appointment, not a two-week wait.
No hourly billing and no change orders once your basement floor is already open.
Thermal imaging helps us confirm whether a stain is active moisture or an old, already-fixed leak.
We scope every Basement Waterproofing job in person before quoting it, since two properties with the same symptom rarely need the same fix.
We route drain tile beneath the existing slab line so flooring disruption stays minimal during installation.
Battery backup is available for any sump system, so a power outage during a storm doesn't undo the whole fix.
The cove joint where the floor meets the foundation wall is one of the most common Portland, OR leak points, and we seal it as part of every interior system.
A dimpled plastic membrane behind any finished basement wall channels residual moisture down to the drain tile instead of trapping it behind drywall.
Window wells that hold water after a storm are a direct pressure point against the glass and frame — we add gravel beds and drain lines tied into the main system.
You describe what you're seeing — a wet spot, a musty smell, standing water — and we get a rough read on urgency before dispatching anyone.
A technician walks the basement with a moisture meter, checking walls, floor, and cove joints to trace the water back to its actual source.
You'll see drain tile footage, sump specs, and labor broken out separately, not one vague lump-sum number.
Most residential basement jobs finish in one to three days, and we test the sump pump under load before we leave.
"Our finished basement started smelling musty and we finally found a wet spot behind the drywall. They cut open the cove joint, ran drain tile, and it's been dry for over a year."
— Portland Homeowner
"Sump basin was undersized from the last owner's DIY job. They resized it and we haven't had a drop since."
— Portland Customer
"They walked us through exactly why the water was coming in before quoting anything, which no one else had bothered to do."
— Portland Homeowner
"Installed a battery backup sump pump for us right before a big storm season — glad we did it when we did."
— Portland Customer
Cost depends on linear footage, sump basin size, and whether cove joint sealing is included — we won't give a number without an in-person inspection.
We keep the cut as narrow as possible and clean up debris before leaving the site.
Most residential interior drain tile and sump installations finish in one to three days depending on basement size.
Not always — an isolated, non-leaking crack can sometimes be handled with injection alone.
Coverage depends on your policy and the cause of the water intrusion — we can document conditions for a claim, but approval is up to your insurer.
Warranty terms are often transferable if you sell the property later.
If your Portland address falls just outside our standard coverage zone, call anyway — we often still make the trip for basement emergencies.
Zip codes we serve in Portland, OR: 97227 97221 97220 97229 97203 97202 97201 97206 97205 97204 97209 97208 97258 97266 97218 97236 97232 97233 97230 97239 97219 97214 97215 97216 97217 97210 97211 97212 97213 97207 97228 97238 97240 97242 97250 97251 97252 97253 97254 97256 97280 97282 97283 97286 97290 97291 97292 97293 97294 97222 97223 97224 97225 97267
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
