We start by pumping out any standing water, then move straight into liner installation and humidity control.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
No hourly billing — the number we quote is the number on the final invoice.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
Every Arab, AL Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Open foundation vents pull in humid outside air, which is often the real driver of Arab, AL crawl space condensation — we seal them as part of encapsulation.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
This helps us bring the right liner thickness and dehumidifier size on the first visit.
A technician physically enters the space to check for standing water, existing liner condition, vent count, and duct exposure.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Found out our old vapor barrier had huge gaps at every seam. They redid it properly and sealed the vents too."
— Arab Homeowner
"Wood floors upstairs were starting to cup from crawl space humidity. Encapsulation plus a dehumidifier stopped it before we had to replace flooring."
— Arab Customer
"They caught duct condensation we didn't even know was happening down there. Sealed everything up during the same visit."
— Arab Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Arab Customer
We can scope either option depending on your budget and how severe the existing moisture problem is.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
In most Arab, AL climates, yes — open vents pull in humid air that undoes a lot of the benefit of the liner alone.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout Arab and the surrounding Arab, AL service area, including the zip codes listed below.
Zip codes we serve in Arab, AL: 35016
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
