We start by pumping out any standing water, then move straight into liner installation and humidity control.
Tuscaloosa, AL crawl spaces vary a lot in how they were originally built, and a liner that's correct for one home can be undersized for another depending on foot traffic and storage use. We size thickness to how the space is actually used.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Tuscaloosa, AL crawl space calls get scheduled fast, especially when there's standing water or an active mold smell involved.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
Liner thickness is selected based on foot traffic and how the space will be used going forward, not a flat default.
Open foundation vents pull in humid outside air, which is often the real driver of Tuscaloosa, AL crawl space condensation — we seal them as part of encapsulation.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
A technician physically enters the space to check for standing water, existing liner condition, vent count, and duct exposure.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
Most residential encapsulations finish in one to two days depending on square footage and access.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Tuscaloosa Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Tuscaloosa Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Tuscaloosa Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Tuscaloosa Customer
We can scope either option depending on your budget and how severe the existing moisture problem is.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout Tuscaloosa and the surrounding Tuscaloosa, AL service area, including the zip codes listed below.
Zip codes we serve in Tuscaloosa, AL: 35475 35476 35405 35404 35406 35401 35487 35403 35407 35486
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
