We start by pumping out any standing water, then move straight into liner installation and humidity control.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
Every Lilburn, GA Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
This helps us bring the right liner thickness and dehumidifier size on the first visit.
We take humidity and moisture readings to establish a baseline before recommending a system.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
Most residential encapsulations finish in one to two days depending on square footage and access.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Lilburn Homeowner
"Wood floors upstairs were starting to cup from crawl space humidity. Encapsulation plus a dehumidifier stopped it before we had to replace flooring."
— Lilburn Customer
"They caught duct condensation we didn't even know was happening down there. Sealed everything up during the same visit."
— Lilburn Homeowner
"Musty smell in our upstairs hallway is completely gone now that the crawl space is sealed."
— Lilburn Customer
We can scope either option depending on your budget and how severe the existing moisture problem is.
We'll recommend a thickness based on how the space is actually used, not just a default.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
Often yes, if the crawl space is the source — sealing and dehumidifying typically resolves musty odors within a few days of installation.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Spaces with extensive prior water damage or debris may take longer — we'll give you a realistic estimate up front.
Tight access or an unusually large crawl space? Call +1-866-476-1348 and we'll confirm scope and scheduling for your specific Lilburn property.
Zip codes we serve in Lilburn, GA: 30047 30048
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
