We start by pumping out any standing water, then move straight into liner installation and humidity control.
Lansing, IL crawl spaces vary a lot in how they were originally built, and a liner that's correct for one home can be undersized for another depending on foot traffic and storage use. We size thickness to how the space is actually used.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Lansing, IL crawl space calls get scheduled fast, especially when there's standing water or an active mold smell involved.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
We also check subfloor insulation for water damage and replace anything compromised before closing the liner.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
A technician physically enters the space to check for standing water, existing liner condition, vent count, and duct exposure.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Found out our old vapor barrier had huge gaps at every seam. They redid it properly and sealed the vents too."
— Lansing Homeowner
"Wood floors upstairs were starting to cup from crawl space humidity. Encapsulation plus a dehumidifier stopped it before we had to replace flooring."
— Lansing Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Lansing Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Lansing Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
In most Lansing, IL climates, yes — open vents pull in humid air that undoes a lot of the benefit of the liner alone.
Often yes, if the crawl space is the source — sealing and dehumidifying typically resolves musty odors within a few days of installation.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
Tight access or an unusually large crawl space? Call +1-866-476-1348 and we'll confirm scope and scheduling for your specific Lansing property.
Zip codes we serve in Lansing, IL: 60438
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
