We start by pumping out any standing water, then move straight into liner installation and humidity control.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
Liner thickness is selected based on foot traffic and how the space will be used going forward, not a flat default.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
We take humidity and moisture readings to establish a baseline before recommending a system.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Plainfield Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Plainfield Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Plainfield Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Plainfield Customer
We can scope either option depending on your budget and how severe the existing moisture problem is.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
In most Plainfield, IN climates, yes — open vents pull in humid air that undoes a lot of the benefit of the liner alone.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Standing water doesn't disqualify a space from encapsulation; it's just the first step in the process.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout Plainfield and the surrounding Plainfield, IN service area, including the zip codes listed below.
Zip codes we serve in Plainfield, IN: 46168 46231
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
