We start by pumping out any standing water, then move straight into liner installation and humidity control.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Jessup, MD crawl space calls get scheduled fast, especially when there's standing water or an active mold smell involved.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
A dedicated crawl space dehumidifier is sized to your square footage, not a one-size-fits-all unit.
Every Jessup, MD Crawl Space Encapsulation job starts with an inspection, not a generic package — here's what that typically includes.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
This helps us bring the right liner thickness and dehumidifier size on the first visit.
A technician physically enters the space to check for standing water, existing liner condition, vent count, and duct exposure.
You'll see square footage, liner grade, vent sealing, and dehumidifier specs broken out in the written estimate.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Found out our old vapor barrier had huge gaps at every seam. They redid it properly and sealed the vents too."
— Jessup Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Jessup Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— Jessup Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Jessup Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
Tight access or an unusually large crawl space? Call +1-866-476-1348 and we'll confirm scope and scheduling for your specific Jessup property.
Zip codes we serve in Jessup, MD: 20701 20794
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
