Heavy-gauge vapor barriers, sealed foundation vents, and a dedicated sump discharge line so your Riverdale, MD crawl space stops feeding moisture into the floor joists above it.
Riverdale, MD crawl spaces vary a lot in how they were originally built, and a liner that's correct for one home can be undersized for another depending on foot traffic and storage use. We size thickness to how the space is actually used.
We follow manufacturer specs on liner overlap and seam tape so the barrier actually holds up over time.
Riverdale, MD crawl space calls get scheduled fast, especially when there's standing water or an active mold smell involved.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
A dedicated crawl space dehumidifier is sized to your square footage, not a one-size-fits-all unit.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
We install heavy-duty liner rated for crawl space conditions, sealed at every seam and pier to stop ground moisture from reaching the floor joists.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
We ask about standing water, musty odor, and vent condition to gauge scope before scheduling the inspection.
We take humidity and moisture readings to establish a baseline before recommending a system.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
Most residential encapsulations finish in one to two days depending on square footage and access.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Riverdale Homeowner
"Wood floors upstairs were starting to cup from crawl space humidity. Encapsulation plus a dehumidifier stopped it before we had to replace flooring."
— Riverdale Customer
"They caught duct condensation we didn't even know was happening down there. Sealed everything up during the same visit."
— Riverdale Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Riverdale Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
In most Riverdale, MD climates, yes — open vents pull in humid air that undoes a lot of the benefit of the liner alone.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Spaces with extensive prior water damage or debris may take longer — we'll give you a realistic estimate up front.
We encapsulate crawl spaces throughout Riverdale and the surrounding Riverdale, MD service area, including the zip codes listed below.
Zip codes we serve in Riverdale, MD: 20737
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
