A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Not every Savannah, GA basement needs full-perimeter drain tile — sometimes a targeted section addressing the actual entry point is the more cost-effective, equally durable fix. We size the scope to what the inspection actually shows.
Every technician is trained specifically on interior drain tile layout, slope, and tie-in to the sump system.
Most Savannah, GA inspection requests get a response within a day or two.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Every system is tested with a hose before we consider the install complete.
Every Savannah, GA Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
A channel is cut along the slab edge, perforated pipe is laid with proper slope, and gravel backfill allows water to flow freely into the drain.
Basin placement is chosen for the shortest, most direct discharge path away from the foundation.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
The cove joint where wall meets floor is sealed and tied directly into the drain system so water is captured right at the entry point.
We camera-inspect old systems where accessible to determine whether repair or replacement makes more financial sense.
Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
You'll see drain tile footage, basin specs, and any cove joint work broken out in the written estimate.
We test the system with water flow before finishing to confirm proper slope and basin performance.
"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Savannah Homeowner
"Cove joint had been the source of our leak for years and nobody had addressed it until now."
— Savannah Customer
"Explained the slope requirements in a way that actually made sense, not just technical jargon."
— Savannah Homeowner
"Sump basin placement was smarter than what a previous contractor had proposed — shorter discharge run, less noise."
— Savannah Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
We'll recommend whichever fits your basement's finish level and budget.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
An undersized basin cycles the pump too often, so we don't cut corners on sizing.
If disruption is a major concern, we can discuss the baseboard channel alternative instead.
Most residential installs finish in one to three days depending on perimeter length and whether cove joint sealing is included.
We install and repair interior drainage systems throughout Savannah and the surrounding Savannah, GA service area, including the zip codes listed below.
Zip codes we serve in Savannah, GA: 31302 31409 31408 31401 31405 31404 31407 31406 31421 31419 31415 31403 31412 31416 31418 31420
One call gets you a licensed specialist, a written quote, and a same-day time window.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
