A properly installed interior perimeter drain system intercepts groundwater at the slab edge and routes it to a sump basin before it ever reaches your floor.
Not every Sherwood, OR basement needs full-perimeter drain tile — sometimes a targeted section addressing the actual entry point is the more cost-effective, equally durable fix. We size the scope to what the inspection actually shows.
We're licensed and insured for residential and light commercial interior drainage work across Sherwood, OR.
Interior drainage installs are scheduled locally, without routing through a national call center that adds weeks to the timeline.
Pricing is based on linear footage of drain tile needed, quoted in writing after an in-person measurement.
Drain tile that isn't sloped correctly simply won't move water — we verify slope with a level during installation, not just by eye.
Every Sherwood, OR Interior Drainage System job starts with an inspection, not a generic package — here's what that typically includes.
We route the full perimeter or targeted sections depending on where moisture is actually entering, based on the inspection.
Basin placement is chosen for the shortest, most direct discharge path away from the foundation.
For finished basements where cutting the slab isn't practical, a baseboard channel system captures wall seepage without disturbing existing flooring.
We treat the cove joint as part of every interior drainage install, not as a separate add-on.
Existing drain tile that's clogged with silt or has failed slope can often be cleaned or repaired rather than fully replaced.
Tell us where water shows up and under what conditions — heavy rain, snowmelt, or constantly — so we can scope the likely system needed.
A technician checks where water is entering, measures the perimeter, and identifies the best sump basin location for discharge.
We explain why we're recommending full perimeter versus targeted sections based on what the inspection found.
We test the system with water flow before finishing to confirm proper slope and basin performance.
"Old drain tile from the 1970s had completely silted up. They cleaned what could be saved and replaced the rest."
— Sherwood Homeowner
"Finished basement meant we couldn't cut the slab easily. Baseboard channel system worked great as an alternative."
— Sherwood Customer
"They tested the system with a hose before calling it done, which gave us confidence it would actually work in a real storm."
— Sherwood Homeowner
"Clean install, patched concrete matched the existing floor color almost perfectly."
— Sherwood Customer
Not always — if water is only entering along one wall, a targeted section can be enough, which we determine from inspection findings.
Drain tile requires cutting the slab; a baseboard channel is a lower-disruption alternative that captures wall seepage without floor demolition.
{Sometimes — if the pipe itself is intact but clogged with silt, cleaning can restore function without a full re-installation.|We camera-inspect where accessible to make that determination before recommending replacement.}
An undersized basin cycles the pump too often, so we don't cut corners on sizing.
Cutting the slab does involve some disruption, but we work in sections and clean up debris as we go.
Most residential installs finish in one to three days depending on perimeter length and whether cove joint sealing is included.
We install and repair interior drainage systems throughout Sherwood and the surrounding Sherwood, OR service area, including the zip codes listed below.
Zip codes we serve in Sherwood, OR: 97140
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
