A properly installed vapor barrier blocks ground moisture from reaching your crawl space or basement floor, sealed at every seam and pier.
A vapor barrier installed without properly sealed seams or wrapped piers provides a fraction of the protection it's supposed to, even though it looks complete at a glance. We follow manufacturer overlap and taping specs on every job.
Seam tape and pier wrapping are done to the standard that keeps warranties valid.
Standard-size crawl spaces and basements can frequently be completed in a single visit.
Pricing is based on your space's actual square footage and liner thickness selected, quoted in writing before installation.
Under-speccing thickness for a heavily used space is one of the most common installation mistakes we see and correct.
We scope every Vapor Barrier Installation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
We overlap seams per manufacturer spec and seal them with rated tape, not just tucked edges that separate over time.
This is often done in coordination with a flooring contractor's timeline, and we can work around scheduled installation dates.
Support piers and posts get individually wrapped and sealed as part of a proper crawl space installation, since unwrapped piers are a common moisture bypass point.
We inspect the full liner before recommending repair versus replacement so you're not paying for a full redo unnecessarily.
We dispose of old material and debris as part of the job, leaving the space ready for the new barrier.
Tell us the square footage, whether it's a crawl space or basement, and how the space is used so we can recommend the right thickness.
We also check for standing water or excessive debris that would need addressing before liner installation.
You'll see the recommended mil thickness, total square footage, and pier wrapping scope broken out with pricing.
Most standard-size installations are completed in a single visit, sealed and ready the same day.
"Old liner in our crawl space was torn and barely covering half the ground. New install with properly sealed seams made an immediate difference in the musty smell."
— Pelham Homeowner
"Recommended a thicker liner since we use the crawl space for storage — made sense once they explained it."
— Pelham Customer
"Quick, clean install — done in one afternoon."
— Pelham Homeowner
"Appreciated the walkthrough at the end showing us exactly where the seams were sealed."
— Pelham Customer
Most residential spaces do well with 12-15 mil; heavier foot traffic or storage use often calls for 20 mil for durability.
We inspect the full barrier during the visit to make that call honestly.
Yes, pier and post wrapping is included in a proper crawl space vapor barrier installation, since unwrapped supports are a common moisture bypass.
No — a vapor barrier is the ground liner itself, while full encapsulation typically adds vent sealing and dehumidification on top of it.
Larger or more complex spaces with extensive pier wrapping may take a bit longer, which we'll flag in the estimate.
We can discuss combining it with dehumidification if the smell doesn't fully resolve.
We install and repair vapor barriers throughout Pelham and the surrounding Pelham, GA service area, including the zip codes listed below.
Zip codes we serve in Pelham, GA: 31779 31739
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
